Mold in an air conditioner or duct system usually starts where moisture collects: a clogged condensate drain, a wet coil or drain pan, or an attic duct that sweats. The fix is to stop the moisture and clean or replace the affected parts. Call the number on this page to be connected with a local mold company in Los Angeles.

What AC and duct mold removal covers
This service deals with mold growing on or inside the equipment that moves air through a home: the evaporator coil, the drain pan, the air handler cabinet, the supply and return ducts, and the vent boots at the registers. A local mold company will look at the system, find where the moisture comes from, and clean or remove what is contaminated. Metal parts can often be cleaned. Fiberglass duct board and flexible duct with a damp, moldy lining are commonly replaced instead, because they are hard to clean well.
When it is needed in Los Angeles
Los Angeles has a dry climate for much of the year, but air conditioning creates its own damp spots. In the San Fernando Valley and other inland areas, ducts often run through hot attics, and cold air in warm attic space can sweat. Near the coast, the marine layer adds humid air to systems that run less often. A drain line that clogs and backs up into the pan is another common cause. Signs include a musty smell when the system starts, visible spotting around a register, or water stains near the air handler.

What happens during the work
- The company inspects the unit, drain line and accessible ducts, and finds the moisture source.
- The system is shut off so spores are not pushed through the house, and the work area is contained.
- Coils, pans and cabinet surfaces are cleaned, and damaged insulation or duct sections are replaced.
- The drain line, insulation and any leaking connections are corrected so the problem does not return.
CDC advises fixing leaks and keeping indoor humidity no higher than 50 percent, and EPA advises keeping it below 60 percent, ideally between 30 and 50 percent. If you have health concerns, talk with your doctor.
What it costs
Published national figures put air duct mold remediation at roughly $600 to $2,000 per job (Bob Vila) and AC or HVAC mold cleaning at roughly $3,000 to $10,000 per job (This Old House). The wide gap reflects whether the job is ducts only or includes the air handler and coil. Quotes in Los Angeles vary with system size, attic access and how much duct is replaced, so compare more than one.
Checking the company
California has no state mold license. A contractor who takes work of $1,000 or more in labor and materials must hold a CSLB license, and you can check the license on the CSLB site before signing. Ask for a written scope that names which duct sections will be cleaned and which replaced.
Renters
If the AC is the landlord's, tell the landlord in writing. California housing law lists visible mold growth as a substandard condition, with an exception for minor mold on surfaces that normally collect moisture. In the City of Los Angeles, the Los Angeles Housing Department takes rental housing complaints.
AC & Duct Mold Removal questions from Los Angeles homeowners
Can mold in the ducts spread through the house?
Should the whole duct system be replaced?
Does a duct cleaning company count as mold remediation?
Will my homeowners insurance pay for it?
Related mold services in Los Angeles
Helpful guides
AC & Duct Mold Removal in nearby cities and towns
Los Angeles County
Orange County
Ventura County
Sources
Last updated: